OVERTURE High Speed PLA Filament 1.75mm 3D Printer Filament,1kg White | Neatly Wound 1kg Spool (2.2lbs) Rapid PLA, Dimensional Accuracy +/- 0.02 mm, Fit Most FDM 3D Printers (White)

Key Features

• 【1 kg PLA Spool x 1 & Build Surface x 1】 Each PLA spool comes with 1 piece of quality 200 × 200 mm / 7.88'' × 7.88'' build surface to support Overture filaments. Grid layout on the surface for easy resizing
• 【Less -tangle and Easy to Use】 Full mechanical winding and strict manual examination, to make sure the line tidy and less-tangle, so as to avoid possible snap and line breaking; Larger spool inner diameter design makes feeding smoother
• International products have separate terms, are sold from abroad and may differ from local products, including fit, age ratings, and language of product, labeling or instructions.

Product Details

Brand

OVERTURE

Model

OVPLA175

Color

White 1-pack

Size

‎1.75 mm Diameter, 1 Kg ( 2.2lb ) Spool

Dimensions

‎22.3 x 7.5 x 20.9 cm; 1 kg

Weight

1 Kilograms

Material

Polylactic Acid

Manufacturer

OVERTURE

Date First Available

17 Feb. 2019

ASIN

B07PGZNM34

Customer Reviews Summary

UPDATE: Amazon does not let me do a separate review for the black PLA, so I am updating this one. I like the black PLA a lot. The surface finish can be a smooth matte black at lower temperatures or glossy at higher. It does have a tendency to warp on smooth steel along with textured PEI, I have to use gluestick and turn the print fan down. But that totally depends on your print surface and other factors, I cannot say for sure if that is a universal issue with Overture Black PLA. Overall I would give the black PLA a 4.5 out of 5 and the white PLA a 4 out of 5. It is some of the better PLA I've used.--- Older review for the white PLA ---These spools claim a consistent diameter of 1.75 give or take 0.05. Most spools I buy claim the same however I have not once actually /seen/ this amount of variance when measuring the diameter. Most spools seem to measure lows and highs of 1.73 - 1.76. Within a one foot stretch of this filament I can see 1.70 to 1.8mm depending on where I measure. That is within the product's described tolerance so I cannot fault it for that. But I cannot wonder if it is the cause of the slight variance in printed layers that is visible when under direct light. Printed 210/72 Prusa MK3S with full Bear Upgrade, textured PEI sheet. Pictures are after some basic extrusion multiplier adjustment and LA calibration @ .2mm layer height.Like any filament purchase there are far too many variables to judge quality off of the finished print. Not to mention differences in color and batch. I have had small difficulties with adhesion but again that could just be me. I have not yet tried the black roll that I ordered.So to summarize, if you see it and it's cheap and you aren't nutty about quality or consistency, it's fine. However it is not my favorite. It is OK and gets the job done.